You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch

SIMULATION

You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch.

The network must meet the following parameters:

– The SSIDs need to be configured as CorpNet with a key of S3cr3t!

– The wireless signals should not interfere with each other.

– The subnet the Access Points and switch are on should only support 30 devices maximum.

– The Access Points should be configured to only support TKIP clients at a maximum speed.

INSTRUCTIONS

Click on the devices to review their information and adjust the settings of the APs to meet the given

requirements.

If any time you would like to bring back the initial state of the simulation, please click the Reset All button.

View Answer

Answer: On the first exhibit, the layout should be as follows

Access Point Name AP1

IP Address 192.168.1.3

Gateway 192.168.1.2

SSID corpnet

SSID Broadcast yes

Mode G

Channel 1

Speed Auto

Duplex Auto

WPA

Passphrase S3cr3t!

Exhibit 2 as follows

Access Point Name AP2

IP Address 192.168.1.4

Gateway 192.168.1.2

SSID corpnet

SSID Broadcast yes

Mode G

Channel 6

Speed Auto

Duplex Auto

WPA

Passphrase S3cr3t

Exhibit 3 as follows

Access Point Name AP3

IP Address 192.168.1.5

Gateway 192.168.1.2

SSID corpnet

SSID Broadcast yes

Mode G

Channel 11

Speed Auto

Duplex Auto

WPA

Passphrase S3cr3t!