Instructions
– Enter the IOS commands on the device to verify the network operations and to find the answers for the multiple-choice questions
– THIS TASK DOES NOT REOUIRE DEICE CONFIGURATION
– Click the device to gain access to the console or the device. No console or enable passwords are required
– To access the multiple-choice questions, click the numbered boxes on the left or the top panel
– There are four multiple-choice questions with this task Be sure to answer all our questions before clicking the Next button
The loopback interfaces on R4 with the IP addresses of 10.4.4.4 /32, 10.4.4.5/32. and 10.4.4.6/32 are not appearing in the routing table of R5
Study the following output taken on R1:
R1# Ping 10.5.5.55 source 10.1.1.1
Type escape sequence to abort.
Sending 5.100-byte ICMP Echos to 10.5.5.55, timeout is 2 seconds:
Packet sent with a source address of 10.1.1.1
Why are the pings failing?
A . The network statement is missing on R5.
B . The loopback interface is shut down on R5.
C . The network statement is missing on R1.
D . The IP address that is configured on the Lo1 interface on R5 is incorrect.
Answer: C