You are configuring an IP address on an autonomous access point.
Which interface do you use to configure the IP address?
A . BVI1
B . FastEthernet 0
C . Dot11Radio0
D . VLAN 1
Answer: A
Explanation:
Assigning the IP Address to the BVI When you assign an IP address to the access point by using the CLI, you must assign the address to the bridge-group virtual interface (BVI). Beginning in a privileged EXEC mode, follow these steps to assign an IP address to the access point BVI using the access point console port. Command Purpose Step 1 configure terminal Enter global configuration mode. Step 2 interface bvi1 Enters interface configuration mode for the BVI. Step 3 ip address ip_address net_mask Assigns an IP address and subnet mask address to the BVI.
http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ ap1140aut_getstart.html