When deploying a FusionCompute, if a host has more than 4 Ethernet ports, it is recommended to set the etho and eth1 as management plane network ports at the same time, and bind after the FusionCompute is installed. What kind of method is generally used to bind the management plane network port?

When deploying a FusionCompute, if a host has more than 4 Ethernet ports, it is recommended to set the etho and eth1 as management plane network ports at the same time, and bind after the FusionCompute is installed. What kind of method is generally used to bind the management plane network port?
A . Load grouping based on source and destination MAC
B . Active and standby
C . Load grouping based on polling
D . Load grouping based on source destination port

View Answer

Answer: B