Refer to the exhibit. Which BGP configuration must be applied to make PE3 use both BGP entries in the Cisco Express Forwarding table?A . On PE1, apply nexto-hop-self on both PE2 and PE3 neighbors...
Refer to the exhibit. A service provider is using the configuration to determine traffic paths based on MPLS EXP marking. Which technology is being implemented?A . CBTSB . DS-TEC . PBTSD . IP FBRView...
Which are the two limitations of the predefined NAT solution? (Choose two)A . Only the port-presentation option is availableB . NetFlow and syslog are not supportedC . The predefined mode cannot be turned on...
An engineer is troubleshooting L3VPN traffic loss over the MPLS-enabled core network when new core links were enable. Assuming that the IGP is properly configured, which issue causes a temporary data flow blackholing when...
A service provider is managing a CE that is used to segment multiple customers into dedicate VRFs. OSPF is used as the PE-CE routing protocol the managed CE does not have the customers routes...
In the MVPN profile 3 (Rosen GRE with BGP-AS), which information is included inside of the opaque value?A . Type 2- Root Address: VPN-ID; 0-nB . Type 1-source-PE: Global-IDC . RD:S,GD . Not applicable...
Which component does NSF rely on to ensure that interfaces remain up during switchover and that lower layer protocol state is maintained?A . SSOB . BFDC . IP FRRD . LFAView AnswerAnswer: A
Which option is the benefit of per-link LFA over per-prefix LFA?A . It has a greater applicabilityB . It provides greater protection coverageC . It is simplerD . It enables better bandwidth utilizationView AnswerAnswer:...
A service provider that supports multicast has a requirement to increase network resilience without relying on RPF convergence in the event of a device failure. To achieve this goal, what must the service provider...
Which two statements about the CRS-3 midplane are true? (Choose two)A . The midplane distributes power and provides control plane interconnectionsB . The midplane provides the following engine for Layer 3 routing of user...
