How should the administrator configure the RPs?

Refer to the exhibit.

Every switch shown in the exhibit is an AOS-Switch that runs PIM-SM. A network administrator wants to load-balance the RP role, so Switch-3 and Switch-4 both act as RPs for some of the multicast groups.

How should the administrator configure the RPs?
A . Specify 10.3.3.3 as a static RP address on half of the AOS-Switches and 10.4.4.4 as a static RP address on the other half.
B . Specify 10.3.3.3 as a static RP address on Switch-1. Specify 10.4.4.4 as a static RP address on Switch-2.
C . Specify the candidate RP command on Switch-3. Also specify the candidate RP command on Switch­ 4.
D . Specify Switch-3 and Switch-4 IP addresses as candidate RP addresses on Switch-1. Specify the same candidate addresses on Switch-2.

View Answer

Answer: B