Based on outputs shown in the exhibits, what is the reason that AP12 is seen by two different controllers?

Posted by: Pdfprep Category: HPE6-A48 Tags: , ,

Refer to the exhibits.

Exhibit1

Exhibit 2

Based on outputs shown in the exhibits, what is the reason that AP12 is seen by two different controllers?
A . AP12 connects to a high availability group. MC1 is the active controller, and MC11 is the standby controller.
B . AP12 is a multizone A
C . MC1 is part of the primary zone, and MC11 is part of the datazone.
D . AP12 connects to an MC cluster. MC1 is the A-AAC, and MC2 is S-AA
F . AP12 is in the middle of the boot process. MC1 is the master IP controller, and MC11 is the LMS IP
controller.

Answer: B

Leave a Reply

Your email address will not be published.