A storage administrator wants to add as asynchronous replication session to a pair of Unity systems with an existing synchronous replication session that is operating correctly.
Which configuration steps are needed?
A . Create Replication interfaces on both systems.
Modify the Replication Connection Mode.
Run a Replication Connection Verify and Update operation.
B . Create Replication Interfaces on the source system. Modify the Mode for Replication Connection. Perform a manual Sync operation on the Asynchronous session.
C . Create Replication Interfaces on destination system. Establish FC connectivity using the Synchronous FC Ports of each system. Perform a manual Sync operation on the Asynchronous session.
D . Create Replication Interfaces on both systems. Establish FC connectivity using the Synchronous FC Ports of each system. Run a Verify and Update operation for the Replication Connection
Answer: A
Explanation:
To fully configure asynchronous replication between systems, you must do each of following:
– Configure connectivity for the replication interfaces used by asynchronous replication
– Configure the replication connection between systems
– Configure replication sessions between systems
Note: To fully configure synchronous replication, you must complete each of following:
– Configure connectivity for the synchronous replication interfaces
– Create the synchronous replication management ports
– Configure the replication connection between systems
– Configure replication sessions between systems
Leave a Reply